News-GENCEL STAINLESS STEEL CO., LIMITED

Advantages Of Electric Control Valve

Date:2019-08-21

Advantages Of Electric Control Valve

1, with the power supply is both convenient and economical, the establishment of a series of gas source station costs;

2, with "pneumatic valve + electrical valve positioner + gas source" of the complex way, it does not only increase the cost, but brings a decline in reliability (more links, the factor of poor reliability increased);
3, from the economic point of view, in addition to the cost of eliminating the gas source station, Also eliminate the cost of electrical valve locator: A good import of electrical valve positioner, usually more than 5000~6000 yuan, better in the 8000~10000 price, and this price basically can buy back the above high-reliable electronic actuator;
4, the link reduced, the corresponding reduction of maintenance workload.

PreviousElectric Ball Valve Function Requirements NextStainless Steel Tube



Recommended News

Introduction to the concept and working principle of Ball Valve

Ball valve, defined in standard GB/T21465-2008 "valve terminology" as a valve driven by the stem and rotated around the axis of the stem. It is mainly used to cut off or connect the medium in the pipeline, and can also be used for the adjustment and control of fluid.

Types and advantages of ball valves

Ball valve and plug valve are the same type of valve, only its closure is a sphere, the sphere rotates around the centerline of the valve body to open and close. The ball valve is mainly used to cut off, distribute and change the flow direction of the medium in the pipeline. Ball valve is a new type of valve which has been widely used in recent years.

Working principle and matters needing attention of stainless Steel Ball Valve

Stainless steel ball valve working principle is to rotate the spool to make the valve open or blocked, the ball valve body can be integral, can also be combined.?The following is to introduce you to the stainless steel ball valve related knowledge.?

Installation method and matters needing attention of Ball Valve

Preparation before installation. (1) the front and rear lines of the ball valve are ready. The front and rear pipes should be coaxial and the two flange cover should be parallel. The pipe should be able to bear the weight of the ball valve, otherwise the pipe must be properly supported.